ESP32 S3 5-inch LCD development board 1024x600 with integrated touchscreen compatible with LVGL HMI sensor CAN-Top

This product is a microcontroller development board that supports 2.4 GHz Wi-Fi and Bluetooth 5 (BLE 5). It integrates high-capacity Flash and PSRAM and features an integrated 5-inch LCD screen, enabling smooth operation of GUI programs such as LVGL. Combined with a variety of peripheral interfaces, it allows compatible with the rapid development of ESP32-S3 HMIs and other applications.Equipped with a powerful Xtensa 32-bit LX7 dual-core processor with a main frequency of up to 240 MHz.Supports 2.4 GHz Wi-Fi (802.11 b/g) and Bluetooth 5 (LE) with an integrated antenna.Integrated 512 KB and 384 KB ROM, stacked with 16 MB Flash and 8 MB PSRAM.Integrated 5-inch LCD screen with a resolution of 1024 x 600 pixels and 65K color.Supports I2C interface compatible with capacitive touch control. 5-point touch. Interrupt support (touch version only).Onboard voltage regulator chip. Supports 7V-36V wide voltage power supply.Integrated RTC chip and battery holder. Time is retained when the battery is inserted and the device is powered off.Onboard CAN, RS485, I2C interface, micro SD card slot, MX1.25 2P battery interface, Type 10 digital isolation, and other resources.Input with bidirectional optocoupler isolation. Supports passive and active switching input. Active input supports positive and negative voltage.Output with optocoupler isolation. Stronger drive capability. Sink current up to 450 mA (MAX).Supports flexible clocking. Individual adjustment of module power and other precise controls to achieve a low-power mode in various scenarios.(The product may have printed markings depending on the batch; however, this does not affect its use.)Color: As shownMaterial: Circuit board + LCDPackage Contents:1 * Non-contact development boardOnly the above package contents are included. Other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture to differ slightly from the actual product. The allowable measurement error is +/- 1-3 cm.