Product overview Two replacement pool hoses sized 1.25 inch ID by 59 inch length, designed for above ground pool pump and filter connections. Upgraded replacement hoses come in white and include four metal clamps for a secure fit. Key benefits Direct fit for common filter pumps: compatible with Intex filter pump models 607 and 637, and pumps rated 330GPH, 530GPH, and 1000GPH. Immediate replacement: restores circulation quickly by replacing cracked, brittle, or leaking hoses. Secure connections: four included metal clamps provide reliable clamping to reduce hose slippage when installed correctly. Correct sizing for most above ground setups: 1.25 inch inner diameter and 59 inch length match standard fittings and routing needs. Poolgrade construction: white hose material suitable for routine pool pump use and repeated seasonal handling. Function and performance These hoses connect the pool to the pump and filter assembly to maintain water flow and filtration. Use with compatible pumps listed above to handle the intended flow rates when hoses are properly installed and clamped. The 59 inch length gives ample reach for typical above ground pool layouts while remaining manageable for storage and replacement. Included in the pack Two 1.25 inch x 59 inch white pool hoses Four metal hose clamps Practical use scenarios a worn hose on an above ground pool using an Intex 607 filter pump to restore proper water circulation. Install during seasonal pool setup to connect a 530GPH pump to the skimmer and filter housing. Reroute a pump installation or create a temporary connection when moving equipment by using the included clamps for a secure fit. Simple installation tips Slide the hose onto the pump and pool fittings fully, then tighten clamps until snug. Inspect hose ends and clamps for signs of wear during seasonal maintenance and as needed. This 2 pack provides ready replacement hoses and clamps for above ground pool pump and filter connections compatible with the listed pump models and flow rates.