This adapter card can switch out 2 interfaces through the M.2 (A+E Key) slot of the PC host, and the user can connect 2 SSD solid state drives or mechanical hard drives with interfaces at the same time through the data cable. Adopting the super PCIe 3.0 bus bandwidth, the data transmission speed is much faster than PCIe 2.0. It is widely used in PC computers, servers, industrial computers, consumer electronic devices, and storage devices. Committed to bringing users and players faster, lower power consumption, high reliability and high performance storage solutions. 1. KEY A/E Riser Board. 2. Support NGFF (M.2) 2230 key A/E. 3. Compliant with PCI Express basic specification revision 3.1a. 4. Support PCIe link layer energy saving mode. 5. M.2 to 2 Port SATA3.0 Card(JMB582 Chip). 6. M.2 A+E key. 7. Support port multiplier. 8. Compliant with III revision 3.2. 9. Support -based and -based port multipliers. 10. Support AHCI mode and IDE programming interface. 11. Support native queue (NCQ). 12. Support link energy saving mode (partial and hibernation). 13. Support plug-in detection function. 14. Support drive power control and staggered rotation. 15. Support Partial / Slumber power management status. System Requirements: for 7 (X86 / X64); for 8 / 8.x / 10 (X86 / X64) (built-in driver) / 11; for Linux Colour:Black Material:PCB Package Contents: 1 x M.2 KEY A-E module Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.