5pcs MAX4466 Microphone Amplifier Module Adjustable Gain Breakout Board Electret

Using the MAX4466, an op-amp specifically designed for amplifier, which has supply noise rejection, and the board comes with a 20-20KHz electret microphone soldered on.On the back, we include a small trimmer pot to adjust the gain. Power supply voltage: +2.4V to +5.5V (can be compatible with for , for and other development board motherboards); Power supply rejection : 112dB; Common mode rejection : 126dB; AVOL: 125dB (RL = 100k) rail-to-rail output; Quiescent power supply current: Less than 24A; Gain bandwidth: 600kHz. The output is rail-to-rail so if the sounds gets loud, the output can go up to 5Vpp Applications: This breakout board is used for projects such as voice changers, audio recordingmpling, and audio-reactive projects use . Note:For the performance, use the "quietest" supply available (on an for , this would be the 3.3V supply); For audio-reactive projects, we suggest using an driver library which can take the audio input and 'translate' it into frequencies. The MAX4466 is a micropower operational amplifier optimized for use as a microphone preamplifier. They an perfect combination of optimized gain-bandwidth and supply current, as as low-voltage operation in super packages. Color: purple Material: PCB+metal Using introduction: Connect GND to ground, VCC to 2.4-5VDC. The audio waveform will come out of the OUT pin. The output will have a DC bias of VCC/2 so when perfectly quiet, the voltage will be a steady VCC/2 volts (it is DC coupled). 1.If the audio equipment you're using requires AC coupled audio, place a 100uF capacitor between the output pin and the input of your device. 2.If you're connecting to an audio amplifier has differential inputs or includes decoupling capacitors, the 100uF cap is not required. 3.If you to connect the amp directly to speakers. If you're connecting to a microcontroller pin, you 't need an amplifier or decouplingcapacitor - connect the OUT pin directly to the microcontroller pin.Note:The output pin is not designed to drive speakers or anything the smallest in-ear headphones- you'll need an audio amplifier (such as 3.7W stereo amp)For audio-reactive projects, we suggest using an driver library which can take the audio input and 'translate' it into frequencies.Applications:It is widely used in Cellular phone, Digital repeater, Headphones, Hearing aids, Microphone preamplifier, Portable computer, Speech recognition system . Package Contents:5 x MAX4466 Module(Due to the computer display, the color of the product may be different from the )5 x Pin Only the above package content, other are not included.Note: Light and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.