New IGBT Voltage Capability Transistor Tester Diode MOS Triode LED Voltage Capability Testing Tool Withstand Voltage Tester 110V~2600V IGBT Voltage Capability Transistor Tester Diode MOS Triode LED Voltage Capability Testing Tool Withstand Voltage Tester Features: 1. The output voltage is DC 110~2600V, the voltage adjustment button can be turned clockwise to make the voltage larger, and the counterclockwise rotation voltage becomes smaller. 2. The output current is 0.25~3.4mAh, you can turn the voltage adjustment button clockwise to make the current larger, and turn counterclockwise to make the current smaller. 3. When testing MOSCs, transistors, and Zener diodes, it is recommended to adjust the current to a minimum size of 0.25mA. When testing LED backlight panels, it is recommended to adjust the current to a maximum size of 3.4mAh. 4. Portable size: The small size of this tool is very convenient for daily use, you can put it in the tool bag to carry without taking up too much storage space. 5. Built-in 660 mAh large-capacity lithium battery power supply, can be charged in time through Type-C interface. 6. Wide application: The tool can be widely used in MOS, transistors, IGBTs, diodes, Zener diodes, diode bridge maximum voltage capacity test, voltage verification of capacitors and rheostats, LED backlight and light board testing, etc Specifications: Battery capacity: 3.7V 600mAH Charging port: TYPE-C Input: 5V 1A Charging current: Max.550mA Output voltage: 120-2700V Output current: 0.2-3.8mA Applicable components: MOS transistors/IGBTs/transistors/diodes/electrolytic capacitors/LEDs/MOVs/unidirectional thyristors/rectifier bridges Test target: breakdown voltage value of electronic components Power supply: built-in lithium battery 500mAh Note: 1. Do not use it to test high voltage large electrolytic capacitors such as 450V/220UF. It is possible to test low-voltage capacitors such as 2200UF/35V. 2. If there is no output voltage when pressing the red high-voltage start button, it is likely that the lithium battery voltage is lower than 3.1V, which cannot power the tester and needs to be charged in time. 3. Only when testing the LED and regulator diode, the output current can be adjusted to the maximum value, for testing other components, the output current can be adjusted to the minimum value to avoid damage to the parts Package Included: Carton packaging Standard configuration: main unit *1 + manual *1 + table pen *1 High configuration: host *1 + instruction manual *1 + watch pen *1 + LCR test clip *1 _x000D_