resolution of 128x160 pixels for clear display of texts, and pictures.Via the 1.8-inch TFT display you can leave the computer off and the data directly from your -controller as as the SD card reader on the back of the board.Bright, anti-reflective TFT display with 1.8-inch diagonal screen and integrated SD card reader. resolution of 128x160 pixels gives a clear presentation of , , and images.With a 1.8-inch diagonal screen and 128x160 pixel resolution, the surface and luminous efficient back-light (max. . 50 mA) also allows for use in bright lit environments.Pins required for SD card reader (not included)IO for the most streamlined wiring: (At least 3 IOs are required)1.-directly connected to the reset signal terminal of the microcontroller, this IO can be saved2.-connect to low level, the chip select is valid for a long time, this IO can be saved3.AO-Connect IO control register 4.SDA-Connect IO to control data transmission5.CLK-Connect IO to control SPI bus6.LED-connect the high-level chip with 3.3V backlight and the IO can be savedIO used for standard wiring: (6 IO)1.-Connect IO to control LCD reset2.-Connect IO control chip 3.AO-Connect IO control register 4.SDA-Connect IO to control data transmission5.CLK-Connect IO to control SPI bus6.LED-connect IO to control backlight or PWM to control brightnesssize:57.8x34x7.5mmMaterial:PCBcolour:Black+redPackage Contents:1 * 1.8 inch SPI TFT Display ModuleOnly the above package content, other are not included.Note: Light and different displays may cause the color of the item in the a little different from the real . The measurement allowed is +/- 1-3cm.