The PDB-XT60 has been engineered to provide the highest poible performance and reliability in a 36*50mm & 4 layers PCB. It distributes power from a LiPo pack to 6 ESCs, as well as providing synchronised & regulated DC 5V outputs & linear regulated DC 12V for powering Cameras, Servos, RC receiver, Flight Controllers, Video Transmitters, LEDs, etc.It offers a XT60 socket to connect the LiPo pack conveniently.Description:General:-Input voltage range (3S-4S LiPo operation): 9 - 18V DC-Regulated 5V and 12V outputs-LED power indicators ( 5V & 12V outputs )-6 ESC outputs & 1 pair VCC/GND padsESC outputs:-Continuous current: 25A*4 or 15A*6-Peak current (10 seconds/minute): 30A*4 or 20A*6BEC 5V output:-Designed for RC Receivers, Flight controllers, OSD, and Servos.-DC/DC synchronous buck regulator.-Voltage: 5.0 +/- 0.1VDC-Continuous current: 2 Amps (Max.2.5A 10s/minute)-Output Ripple: 40mV (VIn=16V, VOut=5V@2A load)-Short-circuit tolerant (5 seconds/minute)BEC 12V output:-Designed for Video TX or FPV camera with linear regulator.-The battery should be 4S LiPo (13~18V DC)- Voltage: 12.0 +/- 0.3VDC-Continuous current: 500mA (Max.0.8A 5s/minute)-Short-circuit tolerant (2 seconds/minute)BEC 12V @ 3S LiPo-Output voltage= 3S LiPo voltage -1VPhysical:-Dimensions: 36 x 50 x 4 mm (without XT60)-Mounting: 30.5 x 30.5mm, 3mm- Weight: 7.5g(w/o XT60), 11g(w/ XT60)Features:2oz copper, 4-layers &1.6mm PCB.Built-in XT60 SocketTotal 6 pairs ESC solder tabs are fit for H or X type frame 5V & 12V Output LED indicators & Short circuit tolerant 1 x Matek Systems PDB-XT60