Tool kit- clone of Fox Trek Isostrut 803-01-436 Iso Strut service/rebuild set This auction is a 3 piece set for the trek fox isostrut -._x000D_ 1st we have a Trunnion adaptor for the trek FOX isostut - . This clamps around the isostrut and holds the tabs so you can use it in a vise or some a hand dyno under preasure. This is made from 6061 aluminum and is CNC machined a Trek FOX Isostrut adaptor used to hold the shock during rebuild and to adapt it to a trunnion tool so you can use it on a hand dyno. This is made from 6061 alumminum and is CNC machined for a tight tolorance fit. This has Hardened steel pins and fit a 44mm trunion tool .This fits the same as fox part number 398-00-844._x000D_ Note: You will need a long trunnion tool as the isostrut has a lot of height past the tool._x000D_ The second tool fits the FOX isostrut found on trek bikes -. This tool is used to remove the isostruts negative plate. This is needed for a rebuild or shock service._x000D_ The last item in the auction is for the threaded Trunnion adaptor for the trek FOX isostut - . This threads into where the shock tube would thread so you can dyno the shock using a extra long trunnion tool before assembling or air pressure. This is made from 6061 aluminum and is CNC machined. These all have a raw machined finish. _x000D_