Function: 1. Wentylator exhaust ma even heat dissipation and very low noise, can be used for long-term use. 2. The heating plate is PTC constant temperature heating, the incubation temperature is guaranteed. 3. The panel of this automatic incubator is a chip panel that can achieve one key incubation control. 4. Humidity probe is a digital probe that ma stable performance, can accurately test humidity. 5. Temperature probe ma a precise temperature sensor, accurately collecting information. Specification: Item Type: Automatic Egg Incubator Material: ABS, aluminium Rated Power: 80 W Motor Voltage: 12 V Engine power: up to 4W Engine Operation Mode: Forward/Rearward Egg turning frequency: 2h/time Temperature control range: 37-39 Scope of application: 48 eggs/56 eggs/96 eggs/112 eggs Comments on installation: 1. Find the box as an incubation medium. Intimate reminder: In the process of designing the size of the box, the dimension is generally length 50x width 50x height 35cm (the box is not limited to these two types, here is an example). 2. It is necessary to punch holes in the box and mount accessories. Intimate reminder: Information on the position of the screw hole can be found in the actual product. (Since the panel must be connected to the power supply, add an inner box for safety) 3. The body of the box is ventilated to ensure air circulation. How to use: Setting temperature and humidity parameters 1. Test: After connecting each component, turn on the power, you will hear the alarm sound due to temperature or humidity, manually press to cancel the alarm. 2. Set the temperature and humidity, change the number of incubation days: press the setting button, press “/” to select the desired temperature, set the humidity and the number of days (two days) of incubation at the end press the set to exit the setting. After setting the number of days of incubation, the device will start working after restarting). 3. Alarm low/high temperature: long press the settings button for 3 seconds, press "/", the display will show "AL", then press the settings button, press "/-" to select the low temperature parameter. Long press for 3 seconds, the display shows "AH", and set the high temperature alarm parameters in the sam way as above. 4. Alarm humidity: the factory setting of the humidity parameter is 45%, not ma need to be re-set. (If you want to set this, you can set it according to the method of setting the temperature parameter, and “AS” will appear on the display.) 5. Calibrate temperature sensor reading: set normal temperature reading to 0, the method is the same as above, the display shows “CA”. 6. Upper limit temperature,set lower limit:If HS (upper limit set) is set to 38,2 and LS (lower limit set) is set to 37,4,The original temperature can only be changed from 38.2 to the lower limit, and be 37.2. List of packages: 1 x Panel 1 x Engine 1 x wentylator exhaust 1 x folia 1 x Humidity Probe 1 x temperature probe; 1 x linia connecting the engine 1 x Plug 1 x Manual 12 x Screw 8 x Nut 8 x Seal 8 x Insulation Column Note: 1. The incubator should be prepared by yourself, it can be wood, acrylic, plastic or glass. 2. The temperature of the cooktop can reach 270, during connection and installation it should be isolated with a gasket. 3. A single plate must be purchased separately.