1. The H743 is a 3-6S 36x36mm mini flight controller with a 128MB flash memory, 5V 10V dual BEC. Designed for easy maintenance and low interference. 2. The PCB adopts high-end composite material, which has stronger overcurrent capability and good heat dissipation. MOS adopts high current resistance mos, low energy consumption, and strong load capacity. 3. Using industrial grade , high temperature resistance. High-quality capacitors, strong filtering performance. 4. Intelligent control: The controller has a built-in low-noise button, which can be controlled remotely by one button. 5. Maximum power: The OSD allows you to control your drone with maximum speed and accuracy, while providing a smoother flight. Chip:STM32H743VIT6(480MHZ) Gyro:-42688-P*2 Barometer:DPS310 OSD Chip:AT7456E Black box:128MM LED Program:Support buzzer:Support Input voltage:3-6S Connector:Support BEC:5V/2.5A BEC:10V/2.0A Cam Input:Support USART: UART1,UART2.UART3.UART4.UART6.UART7 Receiver: ELRS(CRSF).TBS(CRSF).SBUS.IBUS.DSM2.DSMX GPS: YES COMPASS: YES HD O3: YES ESC Signal: Dshoot150.Dshot300,Dshot600 USB: TYPE-C Current Port: Yes Voltage Sensor: Yes Firmware: cleanflight/betaflight/inav/ FC firmware: betaflight_4.5.2_STM32H743_JHEH743_HD.hex/ inav_8.0.1_JHEMCUH743HD.hex / arducopter4.6_with_bl.hex Install hole:30.5x30.5x4MM Board size:36x36MM Type:H743 Flight Control+60A 4INI ESC+VTX1600 Color:As Shown Material:PCB Package Contents: 1 * FPV Stack Kit Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.