Name:F7 V3 Flight Controller. MCU:STM32F722. IMU(Gyro):SBMI270. USB Port Type:SType-C. Barometer:SBMP280. OSD Chip:SAT7456E chip. BLE Bluetooth:Supported. Used for Flight Controller configuration Flash FC Firmware Wirelessly:SSupported. Please enter MENU FC Firmware Flasher. Download/Analyze :Supported.Please enter MENU Analyzer. for Air Unit Connection Way:Two ways supported: 6-pin connector or direct soldering. Flash(for ):500MB. BetaFlight Camera Control Pad:Yes(CC pad on the front side). Power Input:3S - 6S Lipo UART: 5 sets(UART1, UART2, UART3, UART4(For FC Telemetry), UART6) ESC Telemetry UART:R4(UART4) :Supported. SDA & SCL pads on front side. Used for magnetometer, sonar, etc. LED Pad:Used for WS2812 LED controlled by Betaflight firmware. Buzzer:BZ+ and BZ- pad used for 5V Buzzer BOOT Button:Supported. [A]. and hold BOOT button and power the FC on at the same time force the FC to enter DFU mode, this is for firmware flashing when the FC gets bricked. [B]. When the FC is powered on and in standby mode, the BOOT button can be used to controller the LED strips connected to LED1-LED4 connectors on the bottom side. By default, short- the BOOT button to cycle the LED displaying mode. Long- the BOOT button to switch between LED mode and -LED mode. Under -LED mode, all the LED1-LED4 strips be controlled by Betaflight firmware. RSSI Input:Supported. Named as on the front side. SmartPort:Use any TX pad of UART for the SmartPort feature. Supported Flight Controller Firmware:BetaFlight(Default), EMUFlight, INAV Specifications: A:Flight Controller Color: As shown Material: PCB Package Contents: 1 * Module Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.