1. Latest ELM327 version for greater for Ford compatibility2. Manufactured modification to include a switch to connect to different CAN buses3. Designed for FORScan software4. Compatible with software venders: FORScan, Elmconfig (Just support Baud rate:34800,pls check before place order), FF2 and FoCCCus, plus moreBasic Features:Reset fault trouble codes parameter ids (PIDs),Change car configuration data,Run tests,Services proceduresMS CAN bus and HS CAN bus supportELM327 USB 25k80 With Switch For Ford DiagnosticCableProduct Introduction:One ELM327 OBDII OBD2 USB with switch. Designed for communicating with for Ford, for Mazda vehicles. With this cable and the one of the supported software vendors you can detected modules which are not visible for regular OBD2 scanners.This includes showing you trouble codes, PIDs, running tests and services procedures which are never displayed by other OBD2 scanners and a standard ELM327.Pin Configurations:Switch outside: HS CAN Occupies pins 6 and 14Switch inside: MS CAN Occupies pins 3 and 11Supported Software:FORScanElmconfig(Just support Baud rate:34800,pls check before place order)FoCCCusModified EML:Please note that many for Ford and for for Mazda models (approximately since 20032004) are equipped with MS CAN bus, in addition to the regular HS CAN bus. In contrast to HS CAN bus, MS CAN bus is not supported by the stock ELM327, because MS CAN is a manufacturerspecific solution and located on nonOBD2 pins. This ELM327 has been modified to allow it to implement the MS CAN bus.ELM327 supports HS CAN from the stock, because for Ford HS CAN completely matches to the OBD2 standards. It occupies pins 6 and 14. MS CAN bus occupies pins 3 and 11.Colour:As ShownMaterial:ABSPackage Contents:1 * Diagnostic Scan ToolOnly the above package content, other products are not included.