This kit uses ARM Cortex- processor (STM32F103C8), and includes a 2.4-inch color TFT display screen, can be used as ARM test development board. Can be secondary development on the basis of this kit, for example, it can be changed to Millivoltmeter, With automatic, regular -shot modes, easy to capture the moment waveform. Comes 1Hz /3.3V wave source. With waveform parameter digital display, including frequency, period, width, duty , MAX./MIN././- Maximum real-time sampling rate: 1Msps Accuracy: 12Bit Sample buffer depth: 1024 bytes Analog Bandwidth: 0 - 200KHz Vertical Sensitivity: 10mV/ - 5V/ (in 1-2-5 increments) Adjustable vertical displacement with indication Input impedance: 1MΩ Maximum input voltage: 50Vpp (1:1 probe), 400Vpp (10:1 probe) Coupling methods include DC/AC/GND Horizontal time range: 10μs/ - 50s/ (in 1-2-5 increments) With automatic, conventional and single trigger modes, it is convenient to capture instantaneous waveforms Trigger with rising or falling edge Adjustable trigger level position with indication Waveform before trigger can be observed (negative delay) Waveform display can be freeze at any time (HOLD function) Comes with 1KHz /3.3V wave source Digital display with waveform parameters, the parameters can be displayed are: frequency, period, width, duty cycle, maximum value, minimum value, average value, -to- value, Save/recall the waveform, the waveform does not disappear when off Colour:Red Material:ABS Size:18 x 12.5 x 3cm Package Contents: 1 * DIY Digital Oscilloscope Kit 1 * Probe Only the above package content, other products are not included. Note: Light and different displays may the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.