["Digital Temperature & Humidity Controller Thermostat & Humidistat Duble Display AC 110V 220V 10A for Incubator Breeding Greenhouse\n\nFeatures:\nThis digital Temperature & Humidity Controller is with wide humidity measuring range and controlling range, comes with a humidity controller sensor probe and a temperature sensor probe.\nThis Temperature & Humidity Controller is an excellent and convenient multifunction device for controlling temperature and humidity.\nThe Temperature & Humidity Controller has the characteristic of high accuracy, high sensitivity, high stability.\nControl temperature by setting the temperature setting value and the difference value.\nCan be installed directly or embedded in industrial control equipment panel, convenient and quick.\n\nSpecification:\nModel: STC-3028\nInput voltage: AC110~220V\nMeasuring temperature range: -20℃～+80℃\nMeasuring humidity range: 00%RH～+RH\nAccuracy: ±1℃, 0.1%RH\nRelay output contact capacity: 10A/240VAC\nfor Shell material: PC + ABS fireproof\nPanel size: 75x34mm/2.95x1.34inch\nInstallation size: 85x70x28mm/3.35x2.76x1.10inch\nCable length: 1m\nColor: Gray\nQuantity: 1 Set\nNote: 1.Please allow 0-1cm error due to manual measurement. pls make sure you do not mind before you bid.\n 2.Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!\n\nPackage includes:\n1 Set Temperature & Humidity Controller\n\n--------\nInstruction:\nKeep \"Up-Triangle 1\" Button depressed for 3 seconds to enter into the status. First group switches on temperature value (default 20℃). Keep \"Down-Triangle 1\" Button depressed for 3 seconds to stop temperature value (default 30℃) and can be adjusted by add and subtract button.\nKeep \"Up-Triangle 2\" Button depressed for 3 seconds to enter into the status. First group switches on Humidity value (default 40%). Keep \"Down-Triangle 2\" Button depressed for 3 seconds to stop Humidity value (default 60%) and can be adjusted by add and subtract button.\nPress \"Down-Triangle 1\" Button & \"Down-Triangle 2\" Button at the same for time, for 3 seconds to reset the factory settings.\n\nTemperature correction\nCorrected value = measured value + error value\nFor example, we measure the temperature at 25.6 degrees, but the actual is 25.8 degrees. You can press 0.0 for both Up-triangle 1 and Down-triangle 1 for 3 seconds. Then set to 0.2. Then the heaviest temperature is 25.6 + 0.2 = 25.8.\nHumidity correction\nAs with temperature correction, press Up-triangle 2 and Down-triangle 2 for 3 seconds simultaneously.\n\nNote:\n\"Up-Triangle 1\" = ▲1\n\"Down-Triangle 1\"=▼1\n\"Up-Triangle 2\" = ▲2\n\"Down-Triangle 2\"=▼2\nIf you have a question, please contact us for help."]