This is a single piece brass pipe fitting connector with two 1/2 in NPT male hex ends. The 1/2 in NPT to 1/2 in NPT male hex nipple reducer is designed to connect 1/2 in NPT female fittings in a compact, durable brass body. Key benefits Durable brass construction for corrosion resistance and long service life in standard piping environments. Hex ends allow easy tightening with standard wrenches in tight or confined spaces. NPT threaded connections provide a secure, leak resistant seal when used with appropriate thread sealant. One piece design minimizes joint complexity and potential leak points. Compact form factor simplifies alignment and installation in limited spaces. Key attributes Material: brass End type: male hex nipple Thread type: NPT (National Pipe Taper) Size: 1/2 in NPT to 1/2 in NPT Configuration: 1 piece pipe fitting connector Compatibility: designed to mate with 1/2 in NPT female fittings Quantity: 1 piece Applications and use cases Connect two 1/2 in NPT female fittings in residential or commercial plumbing, irrigation, or small equipment installations. Extend a short run of 1/2 in NPT piping in tight spaces where a straight connection is required. a damaged nipple in a small hydraulic or pneumatic line to restore a secure, leak resistant connection. Installation tips Clean threads before assembly and apply appropriate PTFE tape or thread sealant to the male threads. Hand tighten and then snug with a wrench, avoiding over tightening which can damage threads. Verify alignment and check for leaks after installation. This product provides a reliable, easy to use solution for joining 1/2 in NPT fittings with a robust brass construction and a hex design for straightforward installation.